Audi ///S6 NAC

Sunday, March 10, 2013

Wednesday, March 6, 2013

Wednesday, February 27, 2013

///S-Team Meeting Aguascalientes, Mexico

Audi ///S-Team Meeting at Aguascalientes, Mexico!!!

Sunday, January 13, 2013

New photos!
at carls jr

at a mall

Thursday, October 18, 2012

Rear plate base finnally arrived!

My rear plate base finally arrived after a lot of problems...

Here the broken base...

Removed...

Finally!

Saturday, October 6, 2012

Friday, September 14, 2012

Water drain...

The other day I cleaned the water drain holes, you need to remove the battery for this and clean the two holes in the photo.

Sunday, September 9, 2012

Audi S6 4.2 V8 mufflers removed test drive...

Friday, September 7, 2012

Thursday, September 6, 2012

Monday, September 3, 2012

Tuesday, August 28, 2012

Monday, August 27, 2012

VAg Com Codes...

Got this codes after installing the K&N...
16497 - Intake Air Temp. Sensor (G42): Signal too High
P0113 - 35-10 - - - Intermittent
16486 - Mass Air Flow Sensor (G70): Signal too Low
P0102 - 35-10 - - - Intermittent

Red a lot of comments about maf problems with cone filters so I returned it :(...

Sunday, August 26, 2012

Red Calipers!!!

Duplicolor brake caliper...

Saturday, August 25, 2012

at Autozone...

buying stuff at Autozone...

Stuff from Autozone...

Friday, August 24, 2012

First ride with K&N air filter!!!

this was recorded with a SGS3 and I discovered it doesnt record low freqs very well :(

Wednesday, August 22, 2012

How to do the Throttle Body Alignment with VCDS

Throttle body cleaning day...

Throttle body cleaning...

before...

Tuesday, August 21, 2012

Testing Samsung Galaxy S3 camera...

Testing the SGS3 camera...

Oxygen Sensor B2 S1 changed!

Hello! after 2.5hours the sensor is changed and also the vacum lines were all f@#$% so I changed everything!

New Sensor - Bosch 0258 003 813

Old sensor, its a different bosch part... mmmmm.... hope this doesnt affect...

New sensor installed, I lubricated with WD40 to remove the old one... there you can see one of the broken vacuum lines

Old sensor and old vacuum line

Initial toughts after like 7kms with the new sensor, Im from 15.8 lts/100km to 14.4 lts/100km I think the ecu needs to adjust parameters and hopefully improve my gas mileage.

Monday, August 20, 2012

Bad Oxygen Sensor B2 S1 :(

Well vag com is trowing me the following codes:

17538 - Fuel Trim; Bank 2 (Mult): System too Lean
P1130 - 35-00 - -
17536 - Fuel Trim; Bank 1 (Mult): System too Lean
P1128 - 35-00 - -
17539 - Oxygen (Lambda) Sensor; B2 S1: Internal Resistance too High
P1131 - 35-10 - - - Intermittent
17549 - Load Calculation Cross Check: Implausible Value
P1141 - 35-10 - - - Intermittent

And I have like 15.7 lt/100km like 6.5km/lt so on friday I bought the O2 sensor Bosch 0258003813, tomorrow I'm going to install it, the engine its pretty tight as you can see in the below photo so wish me luck...